Main Function; Remote Controller Input; Sensitivity; Dmx Input/Output - ACME Color Fusion CF-805 User Manual

Button
MENU To select the programming functions
DOWN To go backward in the selected functions
UP To go forward in the selected functions
ENTER To confirm the selected functions

Remote controller input

By connecting to the 1/4" microphone jack to control the unit via Stand by, Function, and
Mode function.

Sensitivity

To adjust the sound sensitivity
Microphone
To receive audio signal for sound activated.

DMX input/output

For DMX 512 link, use 3-pin XLR plug cable to link the unit together.

4.2. Main Function

To select any of the pre-set functions, press the MENU button until the required one is
shown on the display. Select the function by ENTER button and the display will blink. Use
DOWN and UP button to change the mode. Once the required mode has been selected,
press the ENTER button to setup or it will automatically return to the main functions without
any change after idling 8 seconds. To go back to the functions without any change press the
MENU button. The main functions are shown below:
5E
C. By Universal DMX controller
The fixtures can be remote setting DMX address by universal DMX controller. First,
programming two scenes into one chase and then link the fixtures to the universal DMX
controller. When you run the chase, all series fixtures will set start DMX address
automatically.
In the two scenes, Ch1 and Ch2 for auto DMX address setting mode, the values will never
change. Ch3 and Ch4 for setting the DMX address, Ch3 or Ch4 value must be setting value
together. Ch3 will be only set 0 or 1 and Ch4 will be set from 0 to 255.
DMX start address = (Ch3 x 256) + Ch4 + 1
For example 1：
Setting the four fixtures with DMX start address = 1
1. Edit the scene 1 Ch1=0, Ch2=255, Ch3=0, Ch4=0
2. Edit the scene 2 Ch1=255, Ch2=0, Ch3=0, Ch4=0
3. Programming two scenes into a chase and link the fixtures to the universal DMX
controller.
4. Running the chase and all series fixtures will be setting start DMX address automatically.
For example 2：
Setting the four fixtures with DMX start address = 10
1. Edit the scene 1 Ch1=0, Ch2=255, Ch3=0, Ch4=9
2. Edit the scene 2 Ch1=255, Ch2=0, Ch3=0, Ch4=9
3. Programming two scenes into a chase and link the fixtures to the universal DMX
controller.
4. Running the chase and all series fixtures will be setting start DMX address automatically.
For example 3：
Setting the four fixtures DMX start address = 257
1. Edit the scene 1 Ch1=0, Ch2=255, Ch3=1, Ch4=0
2. Edit the scene 2 Ch1=255,Ch2=0, Ch3=1, Ch4=0
3. Programming two scenes into a chase and link the fixtures to the universal DMX
controller.
4. Running the chase and all series fixtures will be setting start DMX address automatically.
10E