Dmx512 Address Setting; By Led Display Panel; By Ca-T Dmx Tester - ACME Color Fusion CF-805 User Manual

(Display Inversion mode) or
press the MENU button.

5. DMX512 Address Setting

A. By LED Display Panel
1. Each fixture needs to have an address setting to receive the data sent from the controller.
The address number is between 0-511 (usually 0 & 1 are equal to 1). The address, also
know as the start channel, is the first channel used to receive instructions the controller.
2. The fixture uses six channels. (Fixture 1 = 1, Fixture 2 = 7, Fixture 3 = 13, Fixture 4 = 19,
Fixture...)
3. No need to turn the fixture off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the fixture on, it will be ready to
receive DMX signal or run the built-in programs.
B. By CA-T DMX TESTER
The fixture can be set the DMX address remotely by CA-T DMX TESTER. Please refer to
the CA-T user manual to set the DMX address to the fixture.
(Display normal mode), To go back to the functions
9E 6E