Related Manuals for ACME CP-56U
Summary of Contents for ACME CP-56U
-
Page 1: User Manual
CP-56U/64U User Manual Please read the instructions carefully before use Innovation, Quality, Performance... - Page 3 1. The stepper motor might be damaged or the cable connected to the PCB is broken. 2. The motor’s drive IC on the PCB might be out of condition. 8. Fixture Cleaning The cleaning of internal must be carried out periodically to optimize light output. Cleaning TABLE OF CONTENTS frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the fixture’s optics.
- Page 4 1. Safety Introductions errors. Solder a 120-ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture. Each lighting fixture needs to have an address set to receive the data sent by the Please read the instructions carefully which includes important controller.
- Page 5 32W (CP-64U) The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels. • LED CP-56U：total 156pcs, Red 50pcs, Green 53pcs, Blue 53pcs CP-64U：total 212pcs, Red 70pcs, Green 71pcs, Blue 71pcs • Channels Channel 1 = Red...
- Page 6 3. Installation diagram to use your controller to activate the fixture. • Please checkout the voltage before applying power. • Do not connect the fixture to an electrical dimmer System which it could damage the inside electronics. 4. How To Set The Unit 4.1 Main Function To select any of the given functions, press the MENU button up to when the required one is showing on the display.
- Page 7 own DMX address, not need to calculate the DMX channels of each fixture in the chain. (Fixture 1 = 1, Fixture 2 = 5, Fixture 3 = 9, Fixture 4 = 13, Fixture…) No need to turn the fixture off when you change the DMX address, as new DMX address setting will be effect at once.
- Page 8 back to the functions press the MENU button again. Led Display Channel mode Press the MENU button up to when the is showing on the display. Pressing Press the MENU button up to when the is showing on the display. Pressing ENTER ENTER button and the display will blink.