Safety Introductions; Master/Slave Operation; Easy Controller - ACME Color Fusion CF-805 User Manual

B. Master/Slave operation
The fixtures will allow you to link others fixtures together and operate without a controller. In
Master/Slave mode, the first fixture will control the others to give an automatic, sound
activated, synchronized light show. This function is good when you want an instant show.
The first unit it's DMX input cable will have nothing connect it, and the other fixtures will be
set in slave mode automatically. Their DMX input cables connect the last fixture DMX output
cable (daisy chain). Any fixture can act as a Master or as a Slave. Please refer to the
following diagram to link the others fixtures.
C. Easy Controller (by CA-8)
The easy remote control is used only in master/slave mode. There is a
terminator for connect the easy controller inside the fixture. By
connecting the cable into DMX IN waterproof cable entry gland to the
CA-8 terminator of the first fixture, you will find that the remote control
on the first fixture will control all the other fixtures for Stand by, Function
and Mode functions.
13E

1. Safety Introductions

Please read the instructions carefully which includes important
information about the installation, operation and maintenance.
WARNING
Please keep the User Manual for future consultation. Please be sure receive this
instruction booklet.
Unpack and check carefully there is no transportation damage before using the fixture.
Please ensure the voltage and frequency of power supply match the power
requirements of the fixture.
It's important to ground the yellow/green conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing and maintenance.
Use safety chain when fixes this fixture. Don't handle the fixture by taking its head only,
but always by taking its base.
Maximum ambient temperature is Ta : 40℃.
In the event of serious operating problem, stop using the fixture immediately. Never try
to repair the fixture by yourself. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center. Always use the same type spare parts.
Do not connect the device to any dimmer pack.
Do not touch any wire during operation and there might be a hazard of electric shock.
To prevent or reduce the risk of electrical shock or fire, do not expose the fixture to rain
or moisture.
The housing must be replaced if they are visibly damaged.
Do not look directly at the LED light beam while it may cause some eye damaged.
There are no user serviceable parts inside the fixture. Do not open the housing or
attempt any repairs by yourself. In the unlikely event your fixture may require service,
please contact your nearest dealer.
For power supply, do not connect in series much more than 16 units, use
another mains supply for next 16 units.
2E