Replacing The Incline Platform - Precor TRM10/GEN06 Service Manual

Replacing the Incline Platform

1 Set the treadmill circuit breaker in the off position. Remove the AC
line cord from the AC outlet.
2 Carefully, lay the treadmill on its side.
3 Remove the hitch pin and clevis pin that fastens the incline motor
tube to the incline platform. While the incline tube is not fastened
to the incline platform, care must be taken to not allow the incline
tube to rotate. If the incline tube rotates, the incline motor must be
re-calibrated per Procedure, Calibrating the Incline Motor.
4 Remove the two large hitch pins (one each side) from the incline
platform to frame mounting. See Figure Below. Remove the incline
platform mounting pins and remove the incline platform from the
treadmill.
5 Remove the wheels from the old incline platform and remount them on
the replacement incline platform.
6 Set the replacement incline platform in it mounting position. Align
the key in the incline mounting pin with the key way in the frame and
slide the incline mounting pins into place. See Figure Below (Incline
Mounting Pin). Fasten the incline mounting pins with the hitch pins
removed in step 4.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 34: Incline Platform Mounting
Page 96