7 If the incline tube or the incline motor's drive screw has been moved,
re-calibrate the incline motor per Procedure, Calibrating the Incline
Motor, at this time.
8 Fasten the incline tube to the incline platform with the clevis pin
and hitch pin removed in step 3.
9 Set the treadmill in its upright position and thoroughly check it per
Checking Treadmill Operation
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 35: Incline Mounting Pin
(see
"Section 4 - Operation
Verification" on page 9).
Page 97