Precor TRM10/GEN06 Service Manual page 97

6 Set the calibrated incline motor in its mounting position. Replace the
upper clevis and hitch pins.
7 Replace the lower clevis and hitch pins. It may be necessary to
slightly rotate the incline tube to align it so that the clevis pin
may be inserted. To align the hole in the incline tube, rotate it in
the direction that will cause the least amount of rotation to make
alignment possible.
8 Connect the frame ground wire to the treadmill frame with the screw
removed in step 5. Route both incline motor cables as noted in the
incline motor removal procedure.
9 Route both lift motor cables in the cable management clips to hold the
cables away from the jack screw.
10 Insert the incline motor connector in the INCLINE connector on the
power control module.
11 Check treadmill operation per Procedure,
"Section 4 - Operation
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Verification" on page 9).
Checking Treadmill Operation
(see
Page 95