Replacing The Incline Platform; Procedure; Replacing The Lower Pca - Precor Energy Series Service Manual

Replacing the Incline Platform

Procedure

1. Set the treadmill ON/OFF switch in the "OFF" position. Remove the AC power cord from
the AC outlet.
2. Carefully lay the treadmill on its side.
3. Remove the bolt (retain hardware) that fastens the lift motor to the lift platform. Care must
be taken throughout this procedure to not allow the lift motor lift tube to rotate. The lift
motor will require calibration if the lift motor lift tube has rotated.
4. Remove the two bolts (retain hardware) that fasten the lift platform to the frame and
remove the lift platform from the treadmill.
5. Remove the bolts (retain bolts) that fasten the wheels to the lift platform and remove both
wheels from the lift platform.
6. Remove the rubber bumpers (retain bumpers) from the top front end of the lift platform.
7. Install the rubber bumpers into the replacement lift platform.
8. Install both wheels on the replacement lift platform.
9. Set the replacement lift platform in its mounting position, install and tighten bolts.
10. Install the lift motor lift tube to the lift platform.
11. Make sure that the wheels lift platform, and lift motor bolts are securely tightened.
12. Set the treadmill in its normal upright position and test incline operation.

Replacing the Lower PCA

Procedure
Note: If the Lower PCA is replaced, the treadmill calibration must be performed to ensure proper
operation.
© 2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
.
Page 23 of 56