Replacing The End Cap Or Belt Guard - Precor TRM10/GEN06 Service Manual

Replacing the End Cap or Belt Guard

1 Set the treadmill circuit breaker in the off position and unplug the
treadmill's line cord from the AC outlet.
2 Remove the four screws (2 lower screws, each side) that retain the end
cap. Do Not loosen or move the take up roller mounting/adjustment
bolts. Doing so will change the running belt's tension and alignment.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 38: End Cap Mounting
Page 100