Section 2 - General Information; Gen-06/ Trm10 Treadmill Base; Lubricants; Electrical Requirements - Precor TRM10/GEN06 Service Manual

Section 2 - General Information

In This Section

GEN-06/ TRM10 Treadmill Base ...................... 6

Lubricants ........................................ 6

Electrical Requirements ........................... 6

GEN-06/ TRM10 Treadmill Base
This manual covers service information for the GEN-06 / TRM10 Treadmill
Base.
 The GEN-06 treadmill base is defined as any treadmill produced between
April of 2006 and April of 2011. GEN-06 Treadmills include the
following models; C952, C954, C956, and C966.
 The TRM10 treadmill base is defined as any treadmill produced after
April 2011 and is mated to a Pxx console. All of the base and console
combinations are part of the "Experience" line of products.
Lubricants
 Do not apply any lubricants to the deck and belt. Do not use Wax
Blast, silicon sprays, or other applied lubricants. The use of these
lubricants will quickly degrade the low-friction surface of the deck.
 Do not use petroleum based lubricants on mechanical components such as
the lift, as this may result in degradation of nylon gearing
mechanisms. Use only synthetic lubricants such as "Super Lube with
Teflon" or "Mobile One Synthetic" grease (RED).
Use of unapproved lubricants, cleaners, or solvents may void the
treadmill warranty.
Electrical Requirements
It is extremely important that any Precor treadmill be connected to and
operated on a dedicated 20 amp AC branch circuit. A Dedicated Branch
Circuit is defined as a circuit fed by a single circuit breaker feeding a
single load, with a single non-shared neutral providing a return line. A
treadmill operating from a non-dedicated branch circuit or a circuit
breaker of less than 20 amps capacity will not have the necessary power
to operate normally under higher load conditions.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 6