Replacing The Incline Platform; Procedure - Precor Energy Series Service Manual

Replacing the Incline Platform

Procedure

1. Set the treadmill on/off switch in the "off" position. Remove the AC power cord from the AC
outlet.
2. Carefully lay the treadmill on its side.
3. Remove the bolt (retain hardware) that fastens the incline motor to the lift platform. Care must
be taken throughout this procedure to not allow the incline motor lift tube to rotate. The incline
motor will require calibration if the incline motor lift tube has rotated.
4. Remove the two bolts (retain hardware) that fasten the lift platform to the frame and remove
the lift platform from the treadmill.
5. Remove the bolts (retain bolts) that fasten the wheels to the lift platform and remove both
wheels from the lift platform.
6. Remove the rubber bumpers (retain bumpers) from the top front end of the lift platform.
7. Install the rubber bumpers into the replacement lift platform.
8. Install both wheels on the replacement lift platform.
9. Set the replacement lift platform in its mounting position, install and tighten bolts.
10. Install the incline motor lift tube to the lift platform.
11. Make sure that the wheels lift platform, and incline motor bolts are securely tightened.
12. Set the treadmill in its normal upright position and test incline operation.
©2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
.
Page
Page 34
of 5434
Page 34