Precor TRM10/GEN06 Service Manual page 118

16 Check the alignment of the magnet and the auto stop assembly. The
magnet and the auto stop assembly each have an alignment mark on the
top of their housings. The magnet mark and the auto stop mark should
align and the gap should be approximately 3/16 of an inch between the
housings. A 3/16 allen wrench can be used as a feeler gauge to set the
correct gap.
until the magnet and auto housing are properly aligned.
17 Tighten the bolts so the deck is secure. Torque the bolts to 150 inch
pounds.
18 Position the drive belt around the drive roller pulley. Use drive belt
as a handle to assist in sliding the drive roller through the running
belt and into the frame. Hand tighten the mounting bolts into the
drive roller shaft.
19 Make sure the running belt is in the center of the deck, the spacing
should be the same on each side of the running belt to the edge of the
running deck
20 Start tightening the left and right side drive roller mounting bolts.
Move back and forth between the left and right side mounting bolts so
the bolts will tension evenly which will reduce the stress on the
threads of the bolts. The left side drive roller shaft will tighten
flush to the front frame bracket.
21 Using a measuring tape, measure the distance from the front of the
left side drive roller shaft to the front of the frame cross beam and
make note of that measurement.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
If the gap or alignment are off adjust the running deck
Figure 53: Auto Stop Alignment
Page 116