Precor TRM10/GEN06 Service Manual page 119

22 Tighten the right side drive roller bolt until it measures the same
distance as the left side drive roller, shaft to frame. This will
ensure that the drive roller is parallel and square to the front of
the frame.
23 Walk the drive belt onto the motor pulley by rotating the drive motor
flywheel. Be sure the belt is fully seated in the grooves of both
pulleys and correctly aligned.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 54: Measuring Point - Drive Shaft
Figure 55: Measuring Point Frame Cross Beam
Page 117