Running Belt And/Or Deck Replacement - Precor TRM10/GEN06 Service Manual

Running Belt and/or Deck Replacement

Note: Two running belt gauges, Precor part number 20007-101, are
required. It is important that this procedure be followed to maintain
correct drive belt and running belt tension. Improper tensioning of the
belt will lead to premature running belt wear, premature driver roller
bearing failure and premature take up roller bearing failure
1 Remove the end caps from the rear of treadmill to expose the take up
roller mounting bolts. Remove the treadmill's motor cover.
2 Remove the belt guard by pulling the belt guard tabs away from the
frame locking slots and then pulling it off the take up roller shaft.
3 Remove both running deck trim strips.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 47: Belt Guard
Page 111