Section 8 - Replacement Procedures; Replacing The Line Cord - Precor TRM10/GEN06 Service Manual

Section 8 - Replacement Procedures

In This Section
Replacing the Line Cord ........................... 79
Replacing the Circuit Breaker ..................... 81
Replacing the Line Filter ......................... 83
Replacing the Input Module ........................ 85
Replacing the Auto Stop Sensor .................... 87
Replacing the Auto Stop Magnet .................... 89
Replacing Drive Motor ............................. 92
Replacing the Incline Motor ....................... 93
Replacing the Incline Platform .................... 96
Replacing the Power Control Module ................ 98
Replacing the End Cap or Belt Guard ............... 100
Drive Belt Replacement ............................ 102
Replacing the Drive Roller ........................ 105
Take Up Roller Replacement ........................ 109
Running Belt and/or Deck Replacement .............. 111

Replacing the Line Cord

1 Set the treadmill circuit breaker in the off position and unplug the
treadmill's line cord from the AC outlet.
2 Remove the treadmill's hood.
3 Remove the two screws that fasten the AC input panel to the frame.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 20: AC Input Panel
Page 79