Incline Lift Platform Replacement; About; Procedure - Precor GEN06 Series Service Manual

Incline Lift Platform Replacement

About

This procedure provides instruction to remove and replace the Incline Platform.

Procedure

Review entire procedure before starting.
1. Switch the treadmill power to OFF and
2. Remove the front hood.
3. Access the incline platform by carefully laying the treadmill on its side.
4. Disconnect the Lift Motor actuator tube from the incline platform mounting bracket by
removing the hitch pin and clevis pin. Keep fasteners for installation.
NOTE: Be careful to not allow the actuator tube to turn during the removal/in-
stallation process. This will cause the actuator reference gap to change and will
require recalibration of the Lift Motor, see
5. Remove the left and right incline platform hitch pins from the frame mounting brackets
and removal the platform. Keep fasteners for installation.
6. Remove the wheels from the old incline platform and reinstall them on the replacement
incline platform.
7. Set the replacement incline platform in it mounting position. Align the key in the incline
mounting pin with the key way in the frame and slide the incline mounting pins into
place. Secure mounting pins with the hitch pins.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Incline Lift Platform Replacement
1
unplug the power cord.
"Lift Motor Calibration" on page
6 Replacement Procedures
43.
Page 71