Precor TRM10/GEN06 Service Manual page 112

4 Remove the take up roller mounting bolts by releasing the tension
evenly on both sides. Then lift and slide the take up roller out.
5 Slide the new take up roller through the running belt and into place.
Hand tighten both take up roller mounting bolts a few turns only.
6 Replace the roller guard and mounting bolts.
7 Make sure the running belt is in the center of the deck, the spacing
should be the same on each side of the running belt to the edge of the
running deck.
8 Move the running belt so that the seam is underneath the treadmill.
9 Adjust the drive belt tension per the Procedure,
(on page 119).
Tension
10 Tensioning the Running Belt as per
(on page 122) and Running Belt Tracking Adjustment as per procedure
,Running Belt Tracking Adjustment
11 Replace the belt guard, ensuring the belt guard tabs are firmly locked
in the frame locking tabs and snapped onto the take up roller shaft.
12 Replace the end caps and trim strips.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 46: Take Up Roller Mounting Bolt
(on page 124).
Adjusting Drive Belt
procedure,
Tensioning the Running Belt
Page 110