Replacing The Circuit Breaker - Precor TRM10/GEN06 Service Manual

Replacing the Circuit Breaker

1 Set the treadmill circuit breaker in the off position and unplug the
treadmill's line cord from the AC outlet.
2 Remove the treadmill's hood.
3 Remove the two screws that fasten the AC input panel to the frame.
4 Disconnect the wiring from the circuit breaker (2 blue wires on 120
Vac treadmills or 2 blue and 2 brown wires on 240 Vac
treadmills).Note: The figure below is showing a 240 volt
configuration.
5 Lift the AC input panel from the frame and rotate it to expose the
circuit breaker mounting screws.
6 Remove the two screws retaining the circuit breaker and remove the
circuit breaker.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 22: AC Input Panel
Figure 23: AC Input Panel Hardware
Page 81