Technical Data - Siemens FIDAMAT 6 Operating Instructions Manual

Technical description
2.5

Technical data

General comments
Measuring ranges 4, can be switched over internally or
externally;
manual and automatic measuring range
changeover possible
Autoranging Hysteresis, selectable
Smallest possible 0 - 10 ppm
measuring span
Threshold of detection 0.1 ppm
Largest possible 99,999 ppm
measuring span
Concentration units C , C
1
(ppm)
Measured-value Digital concentration reading
display (5 positions with floating point)
Resolution of the digital 0.1% of the measured value
display
Position of normal use Front panel vertical
Conformity CE symbols to EN 50081-1, EN 50082-2
Oven temperature Adjustable between 100-200 °C
(depending on application)
Design, housing
Degree of protection IP 20 as per EN 60529
Dimensions See "Dimensional drawings" diagram
Weight approx. 23 kg
Electrical features
Auxiliary energy 100 - 120 V AC (nominal consumption
range 90 -132 V), 48 - 63 Hz, or
200 - 240 V AC (nominal consumption
range 180 - 264 V), 48 - 63 Hz
Power consumption approx. 150 VA in operation
approx. 350 VA during warming-up
phase
EMC – resistance to Complies with standard requirements of
interference NAMUR NE21 (August 1998)
(electromagnetic
compatibility)
Electrical safety To EN 61010-1,
overvoltage category II
Fuse-protection values 100... 120 V: 4.0 T/ 250
200... 240 V: 2.5 T/ 250
2-14
3
, C , mg C/m
3 6
Gas entry conditions
Permitted measuring-
gas pressure
- With pump Atmospheric pressure
installed
Measuring-gas flow rate 18 ... 60 l/h (0.3 to 1 l/min)
Measuring-gas 0 - 200°C
temperature
Measuring-gas < 90% RH
humidity (RH = relative humidity)
Consumption figures for the gases
Combustion air approx. 350 ml/min
Hydrogen approx. 20 ml/min
Sample approx. 1 l/min
Neutral gas / approx. 2 l/min
calibration gas
Time behavior
Warming-up time At room temperature, approx. 2 - 3 h
Display delay (T90) 2 - 3 s
Attenuation (electrical 0 -100 s, parametrizable
time constant)
Dead time (time for With filter 2 - 3 s
flushing out gas path
inside unit at 1 l/min)
Time for signal < 1 s
p rocessing within unit
Measurement behavior
Output signal fluctuations < 0.75% of smallest measuring
range possible according to
nameplate with electronic
attenuation constant of 1 s (this
corresponds to +/- 0.25% at 2 σ)
Zero-point drift < 0.5% per month of smallest
measuring range possible according
t o nameplate
Measured-value drift < 1% per week of measuring span
concerned
R epeatability < 1% of measuring span concerned
Linearity deviation < 1% of measuring span concerned
Operating manual – A5E00222135-01
FIDAMAT 6 gas analyzer