Overview Of Operator Functions - Siemens FIDAMAT 6 Operating Instructions Manual

5.3

Overview of operator functions

The unit functions are shown below in an overview. This listing corresponds to version 4 of the software.
Subsection of main menu
5.2.1. Diagnosis
5.2.2. Calibration (Code 1)
5.2.3 Measuring ranges
5.2.3 (Code 1)
5.2.4. Parameters (Code 1)
5.2.5 Configuration (Code 2)
Table 5-1: Overview of operator functions
FIDAMAT 6 gas analyzer
Operating manual –A5E00222135-01
Function
no.
1 Factory data
2 Diagnostic values
3 Logbook
4 Display measuring ranges
20 Calibration of zero point
21 Span calibration
22 Setpoint values of zero / span
23 Calibration settings (single and total calibration)
24 AUTOCAL / check (only with option card)
40 Select measuring ranges
41 Define measuring ranges
50 Electrical time constants
51 Limits
52 In and out functions
53 Status messages
54 Graphic representation of measured values
55 Measured-value display
56 LCD contrast
57 Ignite flame
58 Date and time
59 Measurement point changeover
60 Logbook setting
61 Switch internal valves
70 Analog output
71 Relay assignments
72 Binary inputs
73 ELAN configuration
74 Reset
75 Save or load data
76 Suppression of brief fault signals
77 Analog output memory
78 Calibration tolerances
79 Change codes
80 Unit test
81 Language selection
83 Accompanying gas correction
85 Switch valves
86 Linear temperature compensation
87 Fault on/off
88 AK (only with optional board)
90 PROFIBUS configuration (only with optional board)
91 Start-up state
92 Pressure values
93 Units
99 Factory settings
Name of function
Operation
5-9