Siemens FIDAMAT 6 Operating Instructions Manual page 92

Operation
93 Units
99 Factory settings
5-42
In the case of combustion air pressure there is a further value which
can be input in addition to the functions listed above.
•
Min. increase at pump start-up:
When the pump starts the combustion air pressure must rise by this
value for the unit to go into measurement mode. This value can be
changed.
The measurement unit can be changed in this menu. Its name cannot on
the other hand be changed.
The following settings for the units are possible:
ppm C , ppm C , ppm C
1 3
With the aid of this menu the operator can access the factory functions
level. These settings are intended for the exclusive use of maintenance
personnel and are therefore protected by a further code.
When you select this menu a message will appear asking you to input the
code.
, mg C/m³
6
Operating manual –A5E00222135-01
FIDAMAT 6 gas analyzer