Saving And Restoring Smartshutter Mode Configurations (Mode 6); New Menus As Of Lambda 10-3 Firmware Rev. 1.21; Setting Power-Up Defaults (Mode 7); Setting The Speed Defaults For Wheels A, B, & C (Mode 7 1 1|2|3 [0 - 7]) - Sutter Instrument LB10-3 Operation Manual

40
4.11 Saving and 4.11 4.11 4.11 Saving and Saving and

Saving and Restoring SmartShutter Mode Configurations (MODE 6)

Restoring SmartShutter Mode Configurations (MODE 6) Restoring SmartShutter Mode Configurations (MODE 6) Restoring SmartShutter Mode Configurations (MODE 6)
WHEEL: A-25MM 0 1 B-NC
SHUTR: A-N(5/144)
SAVE INFO AS:
GET INFO FROM:
4.12 New Menus as of Lambda 10 4.12 4.12 4.12 New Menus as of Lambda 10- - - - 3 Firmware Rev. 1.21 New Menus as of Lambda 10 New Menus as of Lambda 10
1-ACTIVE WHEEL
5-SHUTTER MODE
4.12.1 4.12.1 Setting Power 4.12.1 4.12.1 Setting Power Setting Power- - - - up Defaults (MODE 7) Setting Power
In Lambda 10-3's programmed with firmware Rev. 1.21 or later, a new command was added
to the main menu called "7 – Defaults". By pressing MODE and then 7, the following menu is
displayed.
1-Set the new default
2-Reset all to factory default
Speed: 1-WA 2-WB 3-WC
Filter: 5-WA 6-WB 7-WC
Setting More Power up Defaults
4.12.1.1 Setting the Speed Defaults for Wheels A, B, & C (MODE 7 1 1|2|3 [0 – 7])
Please enter the new default speed value between 0-7 .....
1-CFG1
4-CFG1
3 Firmware Rev. 1.21 3 Firmware Rev. 1.21 3 Firmware Rev. 1.21
2-SPEED
6-CONFIG
up Defaults (MODE 7) up Defaults (MODE 7) up Defaults (MODE 7)
1-SET THE NEW DEFAULT
2-RESET ALL TO FACTORY DEFAULT
SPEED: 1-WA 2-WB 3-WC
FILTER: 5-WA 6-WB 7-WC
4-Comm_Port
8-Shutter_Mode
DO YOU WANT TO SET OTHER DEFAULT VALUES?
PLEASE ENTER THE NEW DEFAULT SPEED VALUE
BETWEEN 0-7 ......
LAMBDA 10-3 OPERATION MANUAL – REV. 3.03 (20110829)
C-NC
OFF B-
2-CFG2 3-CFG3
5-CFG2 6-CFG3
3-TTL 4-TEST
7-DEFAULT
4-COMM_PORT
8-SHUTTER_MODE
1-YES
U
OFF
0-NO