Table of Contents
Advertisement
WHEEL A (Gen 1
WHEEL A
(Gen 1 – – – – 3) or A (Gen 4)
3) or A (Gen 4)
WHEEL A
WHEEL A
(Gen 1
(Gen 1
3) or A (Gen 4)
3) or A (Gen 4)
SMART
SMART
SMART
SMART
SHUTTER: This 25-pin DSUB connector is used to interface with a filter
SHUTTER:
SHUTTER:
SHUTTER:
wheel that has an integrated SmartShutter or a standalone SmartShutter.
® ® ® ®
UNIBLITZ
UNIBLITZ
: : : : This 15-pin DSUB connector is used to interface with a filter wheel that
UNIBLITZ
UNIBLITZ
is either standalone (has no integrated shutter) or one that has an integrated
®1
Uniblitz
shutter.
TTL IN:
TTL IN: This BNC connector is used optionally for interfacing with a TTL-triggering
TTL IN:
TTL IN:
device that controls the opening and closing control of Shutter A (Uniblitz or
SmartShutter).
TTL OUT: This BNC connector is used optionally to relay out to another device the
TTL OUT:
TTL OUT:
TTL OUT:
TTL signaling coming in on TTL IN.
NOTE: A standalone filter wheel (one
NOTE:
NOTE:
NOTE:
A standalone filter wheel (one that
A standalone filter wheel (one
A standalone filter wheel (one
shutter) can be attached to the 15
shutter) can be attached to the 15
shutter) can be attached to the 15
shutter) can be attached to the 15- - - - pin connector at the same time as a standalone
1
Uniblitz is a registered trademark of Vincent Associates.
Figure 1-10. Generation 2 rear panel electrical connections
Figure 1-11. Generation 3 rear panel electrical connections).
Figure 1-12. Generation 4 rear panel electrical connections.
pin connector at the same time as a standalone
pin connector at the same time as a standalone
pin connector at the same time as a standalone
LAMBDA 10-3 OPERATION MANUAL – REV. 3.03 (20110829)
.
that is not equipped with an integrated
that
that
is not equipped with an integrated
is not equipped with an integrated
is not equipped with an integrated
13
Advertisement
Table of Contents
Need help?
Do you have a question about the LB10-3 and is the answer not in the manual?
Questions and answers