Mpt-Hc V2/Hc-Hqam/9558Hc - Alcatel-Lucent 9500 User Manual

9500 family overview
• Fast Fault Detection (FFD)
• 1+1 HSB with the MPT-HC/HC-HQAM/XP/XP-HQAM/9558HC by means of a
coupling link
• TDM2ETH (MEF 8) over an Epipe
In single NE mode, the MPR-e behaves differently from the MPR-e in standalone mode:
the MPR-e is part of the 7705 SAR as one Network Element. The MPR-e does not have a
dedicated IP address; however, all MPR-e radios connected to 7705 SAR units are
reachable using the 7705 SAR IP address using the MCT Launcher.
See the 7705 SAR OS 6.0 Software Release Notice (3HE07992000xTQZZA, available in
early 2013) and related user guides for information about the 7705 SAR.
In addition to the configurations and topologies described in section 2.1.4.1, the following
radio configuration is available in single NE mode:
• 1+1 HSB SD with the MPT-HC/HC-HQAM/XP/XP-HQAM (RPS module and
coupling link) and two PMCs on the 7705 SAR
Note: This working mode applies to Release 4.1.0.
3.1.4.2.3 — 1+1 HSB in Single NE mode with 7705 SAR only
Two types of couplers are available for the MPT-HC/HC-HQAM/XP/XP-HQAM/
9558HC:
• 3 dB/3 dB balanced coupler
• 1 dB/10 dB unbalanced coupler
Note: The 1+1 configuration with the MPT-HC/HC-HQAM/XP/XP-HQAM/9558HC can be
implemented only with an interconnection cable between the two ODUs.
Note: An MPT-HC/HC-HQAM and an MPT-XP/XP-HQAM can form a 1+1 configuration with
the use of an RPS cord.
Note: This working mode applies to Release 4.1.0.
3.1.5 — MPT-HC V2/HC-HQAM/9558HC
66 MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01