Figure 4.79 - Cross Connection To User Ethernet Port - Alcatel-Lucent 9500 User Manual

Navigator area
See T1-2 in the
4.9.1.4.9.3.5 — E) Cross connection to user Ethernet port
Note: In case of the "One shot tributary configuration" is not fully displayed, check that
you have selected "classic window" setting, if you are using Windows Vista or Windows 7.
To configure a cross connection between an E1/T1 port and a user port:
• First, enter the parameters as explained in the previous paragraphs, then
• In column Service Profile: Select TDM2TDM or TDM2Eth. If TDM2TDM has been
selected the Ethernet user port must be connected to an Ethernet user port of another
MSS-c.
• In column XCO to Port: Select a user port (user 1 to user 4) in the list
• In column MAC Addr: Enter the External IWF MAC address which is used as
Destination Address in Ethernet frames built to carry TDM information in MPR
network
258
Figure 4.78
Figure 4.79 — Cross connection to user Ethernet port
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01