Table of Contents
Advertisement
Navigator area
4.9.1.4.9.3.2 — B) TDM2TDM cross connection (T1 case)
To configure a TDM2TDM cross connection:
•
Select the Port configuration: T1
•
Choose the T1 port you want to configure (between 1 and 16)
•
In the column Enabled: Check the box
•
In the column Flow Id: Enter a valid VLAN Id (between 2 and 4080). Note that
VLAN Id is unique.
•
In the column Service Profile: Select TDM2TDM in the list (default value)
•
In the column Node Timing: Check the box or not. When it is selected, the
regenerated T1 at receiver side are synchronized to the network element clock (NEC).
Note that corresponding incoming TDM flows shall be synchronous to the NEC at
transmit side.
•
In the column XCo to port: Select Radio Port (default value).
The cross connection is established between an T1 port and the Radio port.
•
In the column Cable Length: Select the appropriate length in the list
Port T1-1 is being configured as shown in
256
Figure 4.78 — Cross connection TDM2TDM (T1 case)
MPR-e and MSS-1c User Manual 3DB19901EFAA Edition 01
Figure
4.78.
Advertisement
Chapters
Table of Contents
