To Connect The Probes; Figure 2-3 Bnc Interface Connection; Figure 2-4 Circuit Under Test Connection - Rigol DS1074B Service Manual

RIGOL

To Connect the Probes

DS1000B series digital oscilloscope provides four channel inputs and an external
trigger input.
Please take the following steps to connect the probes.
1. Connect the BNC connector of the probe to the channel input or external trigger
interface. Insert the BNC connector into the interface vertically and turn it
clockwise.
2. Connect the other end of the probe to the circuit under test.
3. Disconnect the circuit when the test is finished. Turn the BNC connector of the
probe anticlockwise and pull it out vertically.
WARNING
When using 10:1 probe, don't input a signal with a voltage higher than the
maximum input voltage.
2-4

Figure 2-3 BNC Interface Connection

Figure 2-4 Circuit Under Test Connection

Chapter 2 To Prepare for Use
DS1000B Service Guide