RIGOL
Set Level to 50%
(Typical)
Edge Trigger
Edge Type
Pulse Trigger
Trigger Condition
Pulse Width Range
Video Trigger
Video Standard&Line
Frequency
Pattern Trigger
Pattern Setup
Alternate Trigger
CH1, CH2, CH3, CH4
Measurement
Cursor
Auto Measure
Note:
[1] Half channel indicates selecting one of CH1 and CH2, or one of CH3 and CH4.
[2] This is the highest specification for the highest model. The specific equivalent sample rate of
each model is as follows.
DS1204B: 50GSa/s
DS1104B: 25GSa/s
DS1074B: 10GSa/s
1-4
Input signal frequency ≥50Hz
Rising, Falling, Rising + Falling
(>, <, =) positive pulse, (>, <, =) negative pulse
20ns to 10s
Support standard NTSC, PAL and SECAM broadcast
standards. The range of the number of lines: 1 to 525
(NTSC) and 1 to 625 (PAL/SECAM)
H, L, X,
,
Edge, Pulse, Video
Manual
Voltage difference between cursors (∆V)
Time difference between cursors (∆T)
Reciprocal of ∆T in Hertz (1/∆T)
Track
Voltage value and time value of waveform
point
Auto
Cursors can be displayed in auto
measurement
Vpp, Vamp, Vmax, Vmin, Vtop, Vbase, Vavg, Vrms,
Overshoot, Preshoot, Freq, Period, Rise Time, Fall Time,
+Width, -Width, +Duty, -Duty, Delay A→B , Delay A→
B
A→B
,Phase
A→B
,Phase
Chapter 1 Specifications
DS1000B Service Guide