Lan Interface Test; Figure 3-6 Lan Setup Interface; Figure 3-7 Remote Control Interface Based On Lan Interface Connection - Rigol DS1074B Service Manual

Chapter 3 Performance Test

LAN Interface Test

Propose: Test whether the LAN interface works normally using IE explorer.
Tools:
A set of DS1000B series digital oscilloscope

A PC with LAN interface

A standard network cable

Steps:
1. Connect the network interface of the PC and the LAN interface of DS1000B using
a network cable.
2. Press Utility  I/O Setting  LAN Set, to enter the LAN setting interface.
3. Press LAN Init  Recall and select OK.
4. Wait for a moment and observe whether "Configured" is displayed in the status
display area (LAN Status). If "Configured" is displayed, the connection succeeds
as shown in the figure below. If characters other than "Configured", please wait.
5. Open the IE explorer of the PC, input the IP address shown on the oscilloscope
into the address bar and click "Enter". At this point, if the webpage is as shown in
the figure below, the connection succeeds.

Figure 3-7 Remote Control Interface Based on LAN Interface Connection

DS1000B Sevice Guide

Figure 3-6 LAN Setup Interface

RIGOL
3-5