General Inspection - Rigol DS1074B Service Manual

RIGOL

General Inspection

When you get a new DS1000B series oscilloscope, please inspect the instrument
according to the following steps.
1. Inspect the shipping container for damage
Keep the damaged shipping container or cushioning material until the contents of
the shipment have been checked for completeness and the instrument has
passed both electrical and mechanical tests.
The consigner or carrier shall be liable for the damage to instrument resulting
from shipment. RIGOL would not be responsible for free maintenance/rework or
replacement of the unit.
2. Inspect the instrument
In case of any damage, or defect, or failure, notify your RIGOL sales
representative.
3. Check the accessories
Please check the accessories according to the packing lists. If the accessories are
incomplete or damaged, please contact your RIGOL sales representative.
Standard Accessories:
Four 1:1 (10:1) passive probes

When the switch of the probe is toggled to 1X, the bandwidth of the passive
probe is about 6MHz, according with 150V CAT II.
When the switch of the probe is set to 10X, the bandwidth of the passive
probe equals the bandwidth upper limit of the oscilloscope, according with
300V CAT II.
A power cord that fits the standard of the destination country.

A USB cable

A CD-ROM (include the

Quick Guide

Warranty

2-2
User's Guide
and PC application software)
Chapter 2 To Prepare for Use
DS1000B Service Guide