Replacing The Attendant Control - Otto Bock B-Series Service Manual

Service work
37
4.8.7

Replacing the attendant control

f Prerequisites:
Switch off the control unit and deactivate the main fuse (see Seite 12).
Remove the back padding.
f Tools: Allen wrench size 5
Removing the attendant control
1) INFORMATION: Note the installed position of the cable connections being loosened.
Follow the attendant control cable and disconnect it at the appropriate place (see Fig. 38, item 1). Remove ad-
ditional cable attachments if necessary (see Fig. 38, item 2).
2) Loosen and remove the screw in the bracket on the back tube (see Fig. 39, item 1).
3) Loosen and remove the clamping lever for the bracket on the back tube (see Fig. 39, item 2).
4) Remove the attendant control with the bracket.
Installing the attendant control
1) Position the attendant control with the bracket on the back tube.
2) Insert and firmly tighten the clamping lever for the bracket on the back tube (see Fig. 39, item 2).
3) Insert the screw in the bracket on the back tube and firmly tighten it (see Fig. 39, item 1).
4) Position and connect the cable for the attendant control according to its original installed position (see Fig. 38,
item 1).
5) Reattach the loosened cable attachments (see Fig. 38, item 2).
38
26 | Ottobock
39
B-Series