Henny Penny EEG-242 Technical Manual page 21

4-1. MODIFYING PRODUCT
SETTINGS (Continued)
Aug. 2014
Filter After X Number of Loads
13. Press ► button until "FILTER AFTER..." flashes in the
left display along, and the number of cook cycles between
filters shows in the right display. Press the product buttons,
or the ▲ and ▼ buttons, to change this value of 0 to 99
loads. This needs set for each product.
>Load Compensation, Load Compensation
Reference, Full Heat, PC Factor<
14. Press ► button until "LD COMP" shows in the
display, along with the load compensation value. This
automatically adjusts the time to account for the size and
temperature of the cooking load.
Press the product buttons, or the ▲ and ▼ buttons, to
change this value of 0 to 20.
15. Press ► button until "LCMP REF" shows in the display
along with the load compensation average temperature.
(if load compensation is set to "OFF", then "_ _ _" shows
in display and setting cannot be programmed) This is the
average cooking temperature for each product. The timer
speeds up at temperatures above this setting and slows
down at temperatures below this setting. Press the product
button, or the ▲ and ▼ buttons, to change this value.
16. Press ► button until "FULL HT" shows in the display
along with the full heat value in seconds, which means
the heat is on as soon as a timer button is pressed, for the
programmed length of time. Press the product buttons,
or the ▲ and ▼ buttons, to change this value of 0 to 90
seconds.
17. Press ► button until "PC FACTR" shows in the display
along with the proportional temperature, which helps to
keep the oil from over-shooting the setpoint temperature.
Press the product buttons, or the ▲ and ▼ buttons, to
change this value of 0 to 50 degrees.
• Use ◄ button to go back to previous menu items.
• Press ► button when finished with the current
product, to return to the "SELECT PRODUCT"
step.
• Press and hold
PROGRAM Mode.
19
Model EEG-241, 242, 243, 244
button to exit PRODUCT