Henny Penny EEG-242 Technical Manual page 20

4-1. MODIFYING PRODUCT
SETTINGS (Continued)
Aug. 2014
To Change Times and Temperatures
7. Press ► button until "COOK TIME" shows in the display,
and then use the product buttons, or the ▲ and ▼buttons,
to change the time in minutes and seconds, to a maximum
of 59:59.
8. Press ► button and "TEMP" shows in the display, along
with the preset temperature on the right side of the display.
Press the product buttons, or the ▲ and ▼ buttons, to
change the temperature. The temperature range is 190°F
(88°C) to 375°F (191°C).
Cook ID Change
9. Press ► button until "COOK ID" shows in the display
along with the product ID. For example, NUG would be
the ID for nuggets. Use the product buttons, or the ▲ and
▼ buttons, to change the ID.
Alarms (1 & 2)
10. Press ► button until "ALRM 1" shows in the left display,
and an alarm time in the right display. Press the product
buttons, or the ▲ and ▼buttons, to set an alarm.
Ex., If a Cook Cycle was set at 3 minutes, and an alarm
was to go off after 30 seconds into the Cook Cycle, "2:30"
would be set in the display at this time. When the timer
counts down to 2:30 the alarm sounds.
After the alarm time is set, press ► button and "ALRM
2" shows in the display, and a second alarm can be
programmed.
Quality Timer (hold time)
11. Press ► button until "QUAL TMR" shows in the display
along with the preset holding time. Press the product
buttons, or the ▲ and ▼ buttons,to adjust holding time, up
to 59:59.
Global Filter Tracking
Include in Filter Count
12. Press ► button until "INCL IN FLTR CNT" flashes in
the display along with "YES" or "NO". Using ▲ and ▼
buttons, change the display to "YES" if that product's Cook
Cycles are to be counted as part of the recommended filter
process. Set to "NO" if it is not to be included. Mixed
Filter Tracking
18
Model EEG-241, 242, 243, 244