Henny Penny EEG-242 Technical Manual page 29

Model EEG-241, 242, 243, 244
5-1. SPECIAL PROGRAM Autolift Enabled (SP-21)
MODE (Continued) Press ► button and "SP-21 AUTOLIFT ENABLED?" flashes
in the left display. Press the ▲ or ▼ buttons to choose "YES
LIFT" or "NO LIFT". If fryer is fitted with the auto-lift option,
SP-21 must be set to"YES LIFT", otherwise, set SP-21 to "NO
LIFT".
Bulk Oil Supply (SP-22)
Press ► button and "SP-22 BULK OIL SUPPLY?" flashes
in the left display. Press the ▲ or ▼ buttons to choose "YES
SUPL" or "NO SUPL". Set to YES if the oil is pumped
into the vats from an outside oil reservoir. Otherwise, set SP-
22 to NO.
Bulk Oil Disposal (SP-23)
Press ► button and "SP-23 BULK OIL DISPOSE?" flashes
in the left display. Press the ▲ or ▼ buttons to choose "YES
DISP" or "NO DISP".Set to "YES DISP" if the oil is pumped
from the vats to an outside oil reservoir when disarding the oil.
Otherwise, set SP-23 to "NO DISP".
Serial Number Log (SP-24)
Press ► button and "SP-24" and "S/N √EDIT" flash in the
displays, along with the serial number of the unit. THIS SERI-
AL NUMBER SHOULD MATCH THE SERIAL NUMBER
ON THE DATA PLATE, ON THE DOORS. IF NOT, IT CAN
BE RECORDED.
Program Code Change (SP-25)
This allows the operator to change the program code (factory
set at 1, 2, 3) used to access Product Programming and Level 2
Program Mode.
Press ► button and "SP-25" and "CHANGE MGR CODE?
1=YES" flash in the display. Press and "ENTER NEW
CODE, P=DONE, I=QUIT show scrolls through the display.
Press the product buttons for new code.
If satisfied with code, press and "REPEAT NEW CODE,
P=DONE, I=QUIT, shows in display. Press same code buttons.
Aug. 2014 27