Henny Penny EEG-242 Technical Manual page 23

5-1. SPECIAL PROGRAM
MODE (Continued)
Aug. 2014
Press and hold the
2"followed by, "SP PROG" and "ENTER CODE" show in the
display.
Enter code 1,2,3, and "SP-1", "TEMP", "FORMAT" show in
the displays.
If a bad code is entered, a tone sounds and "BAD
CODE" shows on the display. Wait a few seconds,
the controls revert back to the cook mode, and repeat
the above steps.
To exit from the Special Program Mode at any time,
press and hold
Degrees Fahrenheit or Celsius (SP-1)
The left display flashes "SP-1" and "TEMP", "FORMAT".
Press the ▲ or ▼ buttons to choose ºF or ºC.
• Use ◄ button to go back to previous menu items
• Press ► button when finished with the current Level 2
step
Language (SP-2)
Press ► button and "SP-2" and "LANGUAGE" flash on the
left display. Press the ▲ or ▼ buttons to select the desired
language.
System Initialization (SP-3)
Press ► button and "SP-3" and "DO SYSTEM INIT" flash
in the display, along with "INIT" on the right display. To reset
the controls to factory default settings, press and hold √ button
and control counts down "IN 3", "IN2", "IN 1". Once display
shows "-INIT-" & *DONE* the controls are reset to factory
defaults.
Audio Volume (SP-4)
Press ► button and "SP-4" and "VOLUME" flash in the left
display. Press the ▲ or ▲ or use product buttons, to adjust the
volume of the speaker, 10 being the maximum value and 1 the
minimum.
21
Model EEG-241, 242, 243, 244
button for 5 seconds until "LEVEL
button for 2 seconds.