Interfaces; Use Conditions Of Memory Switch - Seiko RP-E10 Operation Manual

1.2.3 Interfaces

The printer driver supports the following interfaces.
Serial (Standard: RS-232C)

USB (Standard: Full-Speed)

TCP/IP (Protocol: RAW)

Caution
 If the 7 bits length is set in the serial communication settings, the printer driver cannot
be used.
 For serial connection, the communication settings of the port should match those of
the printer. For the setting method, see "4.4 Port".
 For TCP/IP connection, only RAW protocol is supported (LPR specification is
ignored). (Excluding when the bidirectional support is disabled.)
 For TCP/IP connection, the socket ports of 9100/9101/9102/26100 are used.
If you install a firewall, allow the connection with these ports.

1.3 Use Conditions of Memory Switch

The memory switch needs the following settings.
The memory switch can be changed by the tool. For details, see "5.3 Memory Switch".
MS No.
MS1 – 3
MS5 – 1
MS5 – 2
MS5 – 3
Item
Mark Mode Selection
(Mark Mode)
Automatic Status Response Selection
(Auto Status Back)
Initialized Response Selection
(Init Response)
Print Data Handling When an Error
Occurs (Error Through)
1
0
0
1-2
Settings
*1
:Enable
*2
:Enable
*2 *3
0 :Enable
*4
:Enable