Table of Contents
Advertisement
6.3 Margin
This section describes the margin sizes.
The following descriptions assume that [Orientation] described in "3.2.1 Displaying [Layout]
Window" is set to [Portrait] and [Direction] described in "3.4.5 Displaying [General Settings]
Window" is set to [Front to Back].
There are the following margins in the paper width direction.
Left Margin
The following left margin appears.
Right Margin
The following right margin appears.
Right margin = Output paper width – Paper width – Left margin
Top Margin
The top margin is an area above the print data within the paper size, which does not contain
the print data, plus the length of the paper feed between head and cutter.
The length of the paper feed between head and cutter depends on the combination of
[Margin] in "3.4.5 Displaying [General Settings] Window", and [Paper Cut] and [Feed to Cut
Position] in "3.4.6 Displaying [Paper Cut/Marked Paper Settings] Window".
The following table shows the combinations of the margins, the paper cut, and the feed to cut
position.
Paper Cut
Full Cut
Partial Cut
None
Output Paper Width
58 mm
80 mm
Feed to Cut
Position
Minimum
Margin
Enabled
3 mm
Disabled
0 mm
Enabled
12 mm
Disabled
0 mm
-
0 mm
Left Margin
2 mm
4 mm
Paper feed between head and cutter
Minimum Top
Margin
Bottom Margin
*1
*1
3 mm
*2
*3
0 mm
12 mm
*2
*3
0 mm
0 mm
6-4
Minimum
Maximum
Margin
12 mm
12 mm
*2
0 mm
0 mm
12 mm
12 mm
*2
0 mm
0 mm
0 mm
0 mm
*3
*3
Advertisement
Table of Contents
