Omron ZX2-LDA41 User Manual page 45

Button
Display
Operation
Select the
Press to select
desired value.
[Change numeric value]
Set any value.
Press to set.
ZX2 User's Manual
Description of Operation
Press the button to select the
trigger conditions.
Press the button to apply
the trigger conditions.
When and
are selected,
proceed to the next item, and
when is selected,
proceed to "7 Threshold
setting."
Press the button to display
.
Press the button to enable
setting of the self-trigger level.
Press the button to move
the digit, press the button to
change the numeric value, and
set the self-trigger level.
Press the button to apply
the setting.
Explanation of
Selection Menu
Enter the trigger by using the
timing input or by pressing
the button in the RUN
mode. The period that the
timing signal is ON is the
sampling period.
The sampling period is the
period that the measured
value is lower than the
specified self-trigger level.
The sampling period is the
period that the measured
value is greater than the
specified self-trigger level.
(For details, see page 97.)
Default value: 0.000
* If the button is pressed
when the cursor is at the
right-most digit or the
button is pressed when the
cursor is at the left-most digit,
the setting will be canceled.
Height
CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
FLOW OF
OPERATION
BASIC
SETUP
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
and
Warpage
Double
Sheet
Detection
Thickness
Positioning
Eccentricity
and Surface
Deflection
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
CHARTS
45