Omron ZX2-LDA41 User Manual page 103

Button
Display
Operation
Important
• If zero reset memory is set to ON, the zero reset level will be written in the Amplifier Unit's
non-volatile memory (EEPROM) each time a zero reset is executed.
The EEPROM can be written a maximum of 100,000 times. Writing the zero reset level for
each measurement can, therefore, use up the life of the memory and lead to malfunctions.
3
Display setting at zero reset
Button
Display
Operation
[Change numeric value]
Set any value.
Press to set.
4
Return to RUN mode
Button
Display
Operation
Hold down for
3 seconds
ZX2 User's Manual
Description of Operation
Press the button to apply
the setting.
Description of Operation
Press the button to display
.
Press the button to enable
setting of values at a reset.
Press the button to move
the digit, press the
change the numeric value, and
set the offset level.
Press the button to apply
the setting.
Description of Operation
Hold down the
Out
three seconds to switch to the
RUN mode.
Set the zero reset memory function to set the
reference value to any numeric value.
* If the
button to when the cursor is at the
right-most digit or the
button is pressed when the
cursor is at the left-most digit,
the setting will be canceled.
button for
Explanation of
Selection Menu
Explanation of
Selection Menu
Default value: 0.000
button is pressed
Explanation of
Selection Menu
Zero Reset
CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
FLOW OF
OPERATION
BASIC
SETUP
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
and
Warpage
Double
Sheet
Detection
Thickness
Positioning
Eccentricity
and Surface
Deflection
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
CHARTS
103