Omron ZX2-LDA41 User Manual page 64

Button
Operation
[Change numeric value]
CONTENTS
Press to set.
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
9
FLOW OF
Threshold Setting
OPERATION
(Use CH2 for these settings.)
BASIC
Button
SETUP
Operation
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
and
Warpage
Double
Sheet
Detection
[Change numeric value]
Thickness
Press to set.
Positioning
Eccentricity
and Surface
Deflection
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
[Change numeric value]
CATIONS
INDEX
Press to set.
SETTING
TRANSITION
CHARTS
64
Thickness
Display Description of Operation
Press the
the digit, press the
change the numeric value, and
set the self-trigger level.
Set any value.
Press the
the setting.
Required
Display Description of Operation
Press the
Amplifier Unit to display the
Lit
HIGH threshold.
Press the
setting of the HIGH threshold.
Press the
the digit, press the
change the numeric value, and
Set any value.
set the HIGH threshold.
Press the
the setting.
Press the
the LOW threshold.
Lit
Press the
setting of the LOW threshold.
Press the
the digit, press the
change the numeric value, and
Set any value.
set the LOW threshold.
Press the
the setting.
button to move * If the
button to when the cursor is at the
right-most digit or the
button is pressed when the
cursor is at the left-most digit,
the setting will be canceled.
button to apply
Set the range of measured values to be judged as
PASS by setting the HIGH and LOW thresholds.
button on the CH2 Setting example:
Non-defective product
thickness 3 to 8 mm
button to enable
button to move
Set the MAX and MIN
button to
thicknesses to be regarded
as OK to the HIGH and LOW
thresholds, respectively.
button to apply
* If the
when the cursor is at the
button to display
right-most digit or the
button is pressed when the
cursor is at the left-most digit,
the setting will be canceled.
button to enable
* Set so that the HIGH
threshold is greater than the
LOW threshold.
button to move
button to
button to apply
Explanation of
Selection Menu
button is pressed
Explanation of
Selection Menu
NG
OK
NG
H
8
P
3
L
button is pressed
ZX2 User's Manual