Omron ZX2-LDA41 User Manual page 20

Digital Displays
The information displayed on the main and sub-displays depends on the currently
CONTENTS
selected mode. The default mode is the RUN mode.
When the power is turned ON, the model of Amplifier Unit (ZX2-LDA) will be displayed on
the main display and the channel number will be displayed on the sub-display.
INTRODUCTION
Subsequently, the Sensor Head software version will be displayed on the main display
and the Amplifier Unit software version will be displayed on the sub-display.
PREPARATION
FOR
These details are displayed for approximately five seconds, and then data for the RUN
MEASUREMENT
mode will be displayed.
FLOW OF
OPERATION
Mode
BASIC
RUN
SETUP
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
and
Warpage
Double
Sheet
Detection
Thickness
Positioning
MENU
Eccentricity
and Surface
Deflection
(For details on setting transition charts, see page 158.)
DETAILED
SETTINGS
Alphabet Display Format
TROUBLE-
SHOOTING
The alphabet appears on the main and sub-displays as shown in the following table.
SPECIFI-
CATIONS
A
INDEX
N
SETTING
TRANSITION
CHARTS
20
Part Names and Functions
Main display
(upper section, red)
The measured value (the value
after the measurement conditions
have been reflected) is displayed.
For example, when the hold
function is set, the held value will
be displayed.
Default measured values are as
follows:
Measurement range
NEAR side
+ indication
0
Measurement center distance
The function names are
displayed in order by pressing
the buttons.
B C D E
O P Q R
By pressing the
threshold, LOW threshold, analog output
value, resolution (max. value of measured
value during one second - min. value), current
value (value before execution of zero reset,
hold, scaling and 2-sensor operation), and
BANK are displayed in this order.
FAR side
- indication
The setting for the function displayed on the
main display is displayed.
F G H
S T U
Sub-display
(lower section, orange)
button, the HIGH
I J K L
V W X Y
ZX2 User's Manual
M
Z