Change Temperature; Room Temperature - Honeywell D6 PRO Installation Manual

Display sleep
The controller goes into Display sleep (the screen is dim) after 45
seconds of inactivity. Press
does not change temperature or settings.
Change mode
1. Be sure the controller is not in Display sleep, then press
the system mode.
2. Stop pressing
The ductless unit will beep when it gets a command from the controller.
Symbol
[screen is
blank]

Change temperature

Warmer

Room temperature

Any time the controller is not being interacted with, the current room
temperature is displayed on screen.
Viewing set temperature
Be sure the controller is not in Display sleep, then press
view the current set temperature. The set temperature will "pulse" on
screen. After a short period of time the screen will change to display the
room temperature.
Change temperature
1. Be sure the controller is not in Display sleep, then press
than once to change the set temperature so it is higher or lower in the
current mode.
2. Stop pressing
3. The screen will pulse and then return to the room temperature
display.
o
o
when you reach the mode you want.
Heat mode - the ductless unit warms the space to the
temperature shown on the controller.
Cool mode - the ductless unit cools the space to the
temperature shown on the controller.
Off mode - the ductless unit is turned off
+ -
or when you reach the temperature you want.
to wake up the controller. This button push
Mode
5
o
to change
Cooler
+ -
or once to
+ -
or more