FARGO electronics DTC510 User Manual page 84

RESTRICTED USE ONLY
Resolving the Communication Errors (continued)
Step Procedure
6 Determine if the Parallel Port mode is set correctly.
a. Ensure that the Parallel Port is set to the Enhanced Communication Port
(ECP) mode. (Note: The port mode can be determined by checking the
Device Manager tab in the System Control Panel.)
b. If the port mode is not set to ECP, it will need to be changed in the
computers BIOS. (Note: Refer to the appropriate computer manual for
instructions on how to change the Parallel Port mode.)
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
Fargo Electronics, Inc.
Continued on the next page
84