FARGO electronics DTC510 User Manual page 114

RESTRICTED USE ONLY
Resolving the Pixel failure problems (continued)
Step Procedure
4 Replace the Cleaning Tape.
a. Open the Printer's Top Cover.
b. Pull the Cleaning Cartridge out of the Printer.
c. Open the Cleaning Cartridge by pressing on the release tab of the clear
Cleaning Cartridge Cover and pulling the cover up.
d. Pull up on the used cleaning tape and lift it and the two Tape Rollers out of
the Cartridge. (Note: The Cleaning Roller can stay within the Cartridge.)
e. Insert the two Tape Rollers into the new Cleaning Tape loop.
f. Place the Tape Rollers and the new tape back into the cartridge.

Be sure to orient the new tape loop so that it extends over the Cleaning
Roller once installed.

Place the Roller closest to the cartridge's handle in first and then press
the second Roller into place.
g. Set the clear Cleaning Cartridge Cover back into place.

Be sure the tabs on the cover are seated properly into the slots on the
cartridge as shown below.

When in place, press down on the top of the cover until it snaps shut.
h. Pull on the tape loop's tab to remove the backing from the tape.
i. Insert the Cleaning Cartridge back into the Printer.

Be sure to push down on the cartridge until it clicks into place.

If the cartridge is not inserted properly, the Printer will not feed cards.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
Fargo Electronics, Inc.
Continued on the next page
114