FARGO electronics DTC510 User Manual page 70

RESTRICTED USE ONLY
Troubleshooting the LCD Messages (continued)
Message
Print Data
Print Ribbon Low
Print Ribbon Out
Print Station
Open
Print Timeout
Printhead Temp
Program
Exception
RAM Memory
Error
Ribbon
Jam/Broken
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
Cause
Indicates that the print data
sent to the Printer is corrupt
or has been interrupted.
Indicates that the print
Ribbon will soon run out.
Indicates that the print
Ribbon has run out.
Indicates that the Print
Station is open during
printing.
Indicates that the Printer was
unable to complete the print
process.
Indicates that the Printhead
Temperature Regulator is
not functioning properly.
Indicates that the system
Firmware has detected an
error while attempting to
process the current print job.
Indicates that the Printer's
Memory Module is bad or
not installed properly.
The print Ribbon is either
jammed or broken.
Fargo Electronics, Inc.
Solution
See Communications Errors in
Section 2, page 72.
If printing a large number of cards,
replace the Ribbon now or monitor the
Printer until the Ribbon is gone and
install a new Ribbon.
Install a new Ribbon and press
RESUME to continue.
Close the Station and press the
Printer's RESUME button to continue
or CANCEL to reset the Printer.
See Communications Errors in
Section 2, page 72.
See Resolving the Printhead Temp
Error Message in Section 2, page
107.
See the Updating the Printer's
Firmware procedure in Section 9,
page 275.
See Resolving the DRAM Memory
Error in Section 7, page 247.
See Resolving the Ribbon Jam/Broke
Error Message in Section 2, page
102.
Continued on the next page
70