FARGO electronics DTC510 User Manual page 322

RESTRICTED USE ONLY
Glossary of Terms (continued)
Term
CR-79
CR-80
CR-90
CR-100
Cursor
Darkness
DB-9
DC Motor
DC (Direct Current)
Default
Defrag
DIP switches (Dual
In-line Package
Switches)
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
Definition
A card dimension standard of 2.0625" L X 3.3125" W (+/-0.002"
W, +/-0.005" L) or 52.400 X 84.150 mm.
A card dimension standard of 2.125" X 3.370" (+/-0.002" W, +/-
0.005" L) or 53.975 X 85.598 mm.
A card dimension standard of 2.375" X 3.625" (+/-0.002" W, +/-
0.005" L) or 60.325 X 92.075 mm.
A card dimension standard of 2.625" X 3.875" (+/-0.002" W, +/-
0.005" L) or 66.675 X 98.425 mm.
The marker in the LCD display Window that indicates the active
selection.
A reference to color saturation.
A 9 pin, D-shaped connector, typically used in serial port
interfaces.
A Motor that works on DC with continuous motion.
Electronic flow that is unidirectional, flowing from the positive (+)
to negative (-) of a power source.
A setting or parameter that comes preset from the factory in driver
or Firmware. Performance parameters can be customized in the
driver, but can be reset to the factory values usually through the
push of the default button. The default values for the Firmware
are usually denoted on a label attached to the Printer.
Abbreviation for defragmenting. The process of reformatting data
on a hard drive so that it uses space more efficiently.
A small array of mechanical switches installed on the board that
can be configured to change Printer operations including
providing a variety of self-tests.
Fargo Electronics, Inc.
Continued on the next page
322