FARGO electronics DTC510 User Manual page 298

RESTRICTED USE ONLY
Install the new Card Input Hopper in the dual Hopper units (DTC515/525)
(continued)
Step Procedure
7 a. Confirm that there is a small metal washer in the left hole (toward the front of
Printer) of the three (3) Card Input Hopper screw holes. See below. (Note:
It should be captured within the plastic molding of the Card Input Hopper.)
b. If the washer is missing, use the washer from the old Hopper.
8 Replace the three (3) screws that hold the Card Input Hopper to the Frame.
Caution: Do not tighten these screws.
9 Install the Hopper 1 as described above.
10 Press down on the top of the Card Input Hoppers to apply a bias toward the
bottom of the Printer. (Note: This ensure the Hoppers are seated properly.)
11 While holding the Card Input Hoppers down, tighten the three (3) screws.
12 Discard the old Card Input Hoppers.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
See (above) the hole with the washer.
Fargo Electronics, Inc.
298