FARGO electronics DTC510 User Manual page 140

RESTRICTED USE ONLY
Adjusting the Card Guide Rail (continued)
Step Procedure
3 Slightly loosen the two (2) screws which fasten the Card Guide Rail to the
Printer's main chassis.
4 If the PolyGuard patch is being placed more toward a card's top edge (as
shown), move the Card Guide Rail slightly toward the rear of the Printer
(opposite the direction you would like the patch to move).
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
Fargo Electronics, Inc.
Continued on the next page
140