FARGO electronics DTC510 User Manual page 149

RESTRICTED USE ONLY
Attaching the Card Lamination Module (continued)
Step Procedure
7 Gently tilt the entire Printer and Lamination Module back onto its rear cover, as
shown below. (Note: Be careful not to slide the unit around in this position as
scratching could occur.)
8 Using a Phillips screw driver, insert each of the four (4) screws into the
Baseplate and tighten the screws to secure the Printer to the Lamination
Module's Baseplate.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
Continued on the next page
4 screws to secure
printer to Baseplate
Fargo Electronics, Inc.
149