RESTRICTED USE ONLY
Installing the new Card Input Hopper in the dual Hopper units (DTC515/525)
(continued)
Step
Procedure
3
Slide the Card Input Hopper to the left to remove it from the Track.
4
Remove the second Hopper (see Steps 2 and 3 in this same procedure).
5
Locate and install the new Card Input Hopper 2 (D850253-02).
6
a. Install the new Hopper by sliding it toward the back of the Printer.
b. Ensure that the plastic Guide is set along the Track. See below.
See (above) the Hopper Track.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
Fargo Electronics, Inc.
Continued on the next page
See (above) the Hopper Track.
297